Instructions for Use: Use the tool with the edge at 45 degrees to the wood in a pulling motion. This will allow you to make subtle changes to the shape, and leaves a very smooth surface that requires minimal sanding. The handle is solid aluminum with a special sure grip coating. Turners have requested this tool for years-it's finally here!
Sharpening Instructions: Set a toolrest on the grinder so that you can touch up the bevel after raising the burr three or four times. To raise a burr; rub the flat side with a ceramic slipstone to remove the old burr and then stroke the slipstone along and up on the bevel side to raise a small burr. You will have to lift the stone off of the bevel and onto the edge a bit more each time you do it - that is why you regrind after three or four times. I use a fine ceramic slipstone.
Sharpening Instructions: Set a toolrest on the grinder so that you can touch up the bevel after raising the burr three or four times. To raise a burr; rub the flat side with a ceramic slipstone to remove the old burr and then stroke the slipstone along and up on the bevel side to raise a small burr. You will have to lift the stone off of the bevel and onto the edge a bit more each time you do it - that is why you regrind after three or four times. I use a fine ceramic slipstone.